Configuring the Output of Statistics

This section describes how to set the destination address and port for outputting the aggregated statistics on passing traffic flows.

Procedure

Access the system view.
```
system-view
```

Access the view of the specified aggregation mode.

ip netstream aggregation { as | as-tos | destination-prefix | destination-prefix-tos | prefix | prefix-tos | protocol-port | protocol-port-tos | source-prefix | source-prefix-tos }

Set the source address of the output statistics.
```
ip netstream export source ip-address
```
Set the destination address of the output statistics.
```
ip netstream export host ip-address port
```
You can set a maximum of two destination IP addresses respectively for the active and the standby NSCs.

You can set two destination addresses in the system view and in the aggregation mode view.