auto-recover

Function

The auto-recover command sets the bypass state switchback mode to auto.

The undo auto-recover command sets the bypass state switchback mode to manual.

Format

auto-recover

undo auto-recover

Parameters

None

Views

Bypass link view

Default Level

2: Configuration level

Usage Guidelines

If the device is powered off or restarted unexpectedly, the interfaces in a bypass interface pair automatically enter the bypass state. When the device recovers, the interfaces decide whether to switch back to the non-bypass state according to the setting of the state switchback mode:

When the state switchback mode is set to auto (auto-recover), if the switch bypass command has been configured before recovery, the interfaces stay in bypass state. Otherwise, the interfaces automatically switch to the non-bypass state.
When the state switchback mode is set to manual (undo auto-recover), the interfaces stay in bypass state. To switch the interfaces to the non-bypass state, you need to manually run the undo switch bypass command.

By default, the state switchback mode is auto.

Example

# Set the bypass state switchback mode to auto.

<sysname> system-view
[sysname] bypass-link 0/0/0
[sysname-bypasslink0/0/0] auto-recover