display hrp interface

Function

The display hrp interface command displays the heartbeat interfaces status.

display hrp interface

None

All views

1: Monitoring level

You can view the heartbeat interface status only after running the hrp enable command to enable hot standby.

# Display the heartbeat interfaces status.

HRP_M<sysname> display hrp interface
GigabitEthernet0/0/2 : running
GigabitEthernet0/0/1 : ready

Table 1 shows the description of the display hrp interface command output.

**Table 1** Description of the **display hrp interface** command output
Item	Description
GigabitEthernet0/0/2 : running	A heartbeat interface works in one of the following statuses: running: indicates the currently used heartbeat interface. ready: indicates a standby heartbeat interface. The FW supports a maximum of 16 heartbeat interfaces. If there are multiple heartbeat interfaces, the FW uses one of them to send heartbeat packets, and the others are standby. If the currently used heartbeat interface is faulty, a standby one is used. The configuration sequence determines the priorities of the heartbeat interfaces. invalid: indicates that the interface is unavailable. It is possible that the interface does not have IP addresses or has been switched to the Layer 2 mode. down: indicates that the interface is down. negotiation failed: indicates that the negotiation with the peer device on the active/standby status fails. The possible cause is that the software version of the local device is inconsistent with that of the peer device, the configuration of the local or peer device is incorrect, the peer heartbeat interface is Down, the HRP source or destination port number is changed, or the underlying link is disconnected.