display trunkmembership eth-trunk

Function

The display trunkmembership eth-trunk command displays information about trunk member interfaces.

Format

display trunkmembership eth-trunk trunk-id

Parameters

Parameter	Description	Value
trunk-id	Specifies the ID of an Eth-Trunk interface.	The value is an integer ranging from 0 to 63.

Views

All views

Default Level

1: Monitoring level

Usage Guidelines

Usage Scenario

After an Eth-Trunk interface is successfully configured, you can run the display trunkmembership eth-trunk command to view the configuration of the Eth-Trunk interface and its member interfaces.

In the scenario where you need to monitor the status of an interface or locate an interface fault, you can use the display trunkmembership eth-trunk command to view detailed information about an Eth-Trunk interface and its member interfaces. You can troubleshoot the interface and its member interfaces according to the queried information.

Prerequisites

An Eth-Trunk interface is correctly configured. The Eth-Trunk interface must be created in advance; otherwise, the system prompts an error when you run the display trunkmembership eth-trunk command.

Precautions

Before running the display trunkmembership eth-trunk command to view the configuration of Eth-Trunk interface in static LACP mode, ensure that the mode lacp-static command has been run in the Eth-Trunk interface view to configure the Eth-Trunk interface to work in static LACP mode.

Example

# Display information about the trunk member interfaces.

<sysname> display trunkmembership eth-trunk 0
Trunk ID: 0
used status: VALID
TYPE: ethernet
Working Mode : Normal
Working State: Normal
Number Of Ports in Trunk = 2
Number Of UP Ports in Trunk = 1
Operate status: up

Interface GigabitEthernet0/0/1(10G), valid, operate up, weight=1
Interface GigabitEthernet0/0/2, valid, operate down, weight=1

**Table 1** Description of the **display trunkmembership eth-trunk** command output
Item	Description
Trunk ID	Eth-Trunk interface number
used status	Usage status: valid and invalid
TYPE	Trunk type
Working Mode	Operation mode of the Eth-Trunk interface: Normal: manual load balancing mode Static: indicates the static LACP mode.
Working State	Operation status of the Eth-Trunk interface
Number Of Ports in Trunk	Number of Eth-Trunk member interfaces
Number Of UP Ports in Trunk	Number of Eth-Trunk member interfaces in the Up state
Operate status	Status of the Eth-Trunk interface: up down
Interface GigabitEthernet0/0/1(10G)	Rate of the GE interface that is added to the Eth-Trunk interface: 10 Gbit/s (If the rate is lower than 10 Gbit/s, "(10G)" is not displayed.)