The firewall dynamic-resource used-up alarm traffic-monitor-table threshold command sets the trap threshold on the resource usage of the bandwidth monitoring table.
The undo firewall dynamic-resource used-up alarm traffic-monitor-table threshold command restores the trap threshold on the resource usage of the bandwidth monitoring table to the default value.
firewall dynamic-resource used-up alarm traffic-monitor-table threshold threshold
undo firewall dynamic-resource used-up alarm traffic-monitor-table threshold
| Parameter | Description | Value |
|---|---|---|
| threshold | Specifies the trap threshold on the resource usage of the bandwidth monitoring table. | The value is an integer ranging from 1 to 100, in percentages. |
By default, the trap threshold on the resource usage of the bandwidth monitoring table is 80%.
In the setting of the trap threshold on the resource usage of the bandwidth monitoring table, you must also run the firewall dynamic-resource used-up alarm traffic-monitor-table enable or firewall dynamic-resource used-up alarm all enable command to enable the function of trap sending when the resource usage of the bandwidth monitoring table reaches the trap threshold. Otherwise, the device does not send a trap.
When the resource usage of the bandwidth monitoring table reaches the threshold, log BWM/4/RES_OVER and trap BWM_1.3.6.1.4.1.2011.6.122.63.1.13_hwSecCarMonitorTableOverThreshold is sent. After the resource usage of the bandwidth monitoring table falls below 95% of the threshold, log BWM/4/RES_BELOW and trap BWM_1.3.6.1.4.1.2011.6.122.63.1.14_hwSecCarMonitorTableBelowThreshold is sent.