ip-detect healthcheck

Function

The ip-detect healthcheck command enables the NAT address pool detection function.

The undo ip-detect command disables the function.

Format

ip-detect healthcheck healthcheck-name

undo ip-detect

Parameters

Parameter	Description	Value
healthcheck-name	Specifies the name of a health check.	It must be the name of an existing health check.

Views

Address pool view

Default Level

2: Configuration level

Usage Guidelines

Only the USG6510E/6510E-POE/6530E does not support this command.

Before using the ip-detect healthcheck command, run the healthcheck enable command to enable the health check function and run the healthcheck name command to configure a health check template.

The detection time (detection interval x number of detection failures) of the health check specified by healthcheck-name must be greater than 33s. Otherwise, the healthcheck-name command cannot be used with the ip-detect healthcheck command.

Example

# Enable NAT address pool detection.

<sysname> system-view
[sysname] nat address-group nataddr 1
[sysname-address-group-nataddr] ip-detect healthcheck healthcheck1