nat full-cone global alarm ip-pool port-number threshold

Function

The nat full-cone global alarm ip-pool port-number threshold command sets the threshold for the usage of the address pool port.

The undo nat full-cone global alarm ip-pool port-number threshold command restores the default value.

Format

nat full-cone global alarm ip-pool port-number threshold threshold-value

undo nat full-cone global alarm ip-pool port-number threshold

Parameters

Parameter	Description	Value
threshold-value	Specifies the threshold for the port usage.	The value is an integer ranging from 60 to 100, in percentage. By default, the threshold for the port usage of IP addresses in the address pool is 80.

Views

System view

Default Level

2: Configuration level

Usage Guidelines

In the 3-tuple NAT scenario, use the nat full-cone global alarm ip-pool port-number threshold trap enable command to enable the function of sending alarms on the port usage to monitor the total usage of ports whose IP addresses are in the address pool. When the port usage hits the threshold, the device sends an alarm to the NMS.

Only the USG6510E/6510E-POE/6530E does not support this command.

Example

# Set the threshold for the usage of the address pool port to 90%.

<sysname> system-view
[sysname] nat full-cone global alarm ip-pool port-number threshold trap enable
[sysname] nat full-cone global alarm ip-pool port-number threshold 90