nat no-pat global alarm ip-pool threshold trap enable

Function

The nat no-pat global alarm ip-pool threshold trap enable command enables alarm sending upon the usage of public IP addresses in the NO-PAT address pool.

The undo nat no-pat global alarm ip-pool threshold trap enable command disables alarm sending upon the usage of public IP addresses in the NO-PAT address pool.

Format

nat no-pat global alarm ip-pool threshold trap enable

undo nat no-pat global alarm ip-pool threshold trap enable

Parameters

None

Views

System view

Default Level

2: Configuration level

Usage Guidelines

In the NO-PAT NAT scenario, if you need to monitor the usage of public IP addresses in the address pool, run the nat no-pat global alarm ip-pool threshold trap enable command to enable alarm sending upon the public IP address usage of the address pool. When the public IP address usage of the address pool exceeds the threshold specified in the nat no-pat global alarm ip-pool threshold threshold-value command, the FW sends the hwSecTrapNopatAddrOverThreshold alarm to the NMS. After the public IP address usage of the address pool falls below the threshold, the FW sends the hwSecTrapNopatAddrBelowThreshold alarm to the NMS.

By default, the alarm sending function is disabled.

Example

# Enable alarm sending upon the usage of public IP addresses in the NO-PAT address pool.

<sysname> system-view
[sysname] nat no-pat global alarm ip-pool threshold trap enable