nat srcip-car used-up alarm enable

Function

The nat srcip-car used-up alarm enable command enables the function of sending logs and alarms if the number of private addresses corresponding to the current public address exceeds the threshold.

The undo nat srcip-car used-up alarm enable command disables the function of sending logs and alarms if the number of private addresses corresponding to a public address exceeds the threshold.

Format

nat srcip-car used-up alarm enable

undo nat srcip-car used-up alarm enable

Parameters

None

Views

System view

Default Level

2: Configuration level

Usage Guidelines

By default, this function is enabled. After enabling this function, run the nat srcip-car used-up alarm threshold command to set the threshold.

If the number of private addresses corresponding to a public address exceeds the threshold, the log CARNAT/4/CARNAT_POOL_USEDUP and alarm CARNAT_1.3.6.1.4.1.2011.6.122.18.3.2.13 hwSecTrapSrcIPCarPoolUsedUp are sent. If the number of private addresses corresponding to a public address falls below the threshold, the log CARNAT/5/CARNAT_POOL_NORMAL and alarm CARNAT_1.3.6.1.4.1.2011.6.122.18.3.2.14 hwSecTrapSrcIPCarPoolNormal are sent.

Only the USG6510E/6510E-POE/6530E does not support this command.

Example

# Enable the function of sending logs and alarms if the number of private addresses corresponding to a public address exceeds the threshold.

<sysname> system-view
[sysname] nat srcip-car used-up alarm enable