reset service-manage

Function

The reset service-manage command restores the access control function of the interfaces to the default setting.

Format

reset service-manage

Parameters

None

Views

Ethernet interface view, Ethernet sub-interface view, Eth-Trunk interface view, Eth-Trunk sub-interface view, VLANIF interface view, Tunnel interface view, Dialer interface view, Virtual-Template interface view

Default Level

2: Configuration level

Usage Guidelines

After you run this command, the access control management function of the management interface is enabled, and the administrator is allowed to use HTTP, HTTPS, and Ping to access the device. For non-management interfaces, the access control management function is enabled, but the administrator is not allowed to use HTTP, HTTPS, Ping, SSH, SNMP, NETCONF, or Telnet to access the device.

Example

# Restore the access control function of interface GigabitEthernet 0/0/1 to the default setting.

<sysname> system-view
[sysname] interface GigabitEthernet 0/0/1
[sysname-GigabitEthernet0/0/1] reset service-manage