source-address (user-defined report view)

Function

The source-address command sets the source address or address scope in the user-defined report view for advanced search.

The destination-address command sets the destination address or address scope in the user-defined report view for advanced search.

The undo source-address command cancels the settings of the source address or address scope in the user-defined report view for advanced search.

The undo destination-address command cancels the settings of the destination address or address scope in the user-defined report view for advanced search.

Format

{ source-address | destination-address } ip-address

{ source-address | destination-address } ip-address mask-lenth

{ source-address | destination-address } ip-address mask mask

{ source-address | destination-address } range start-ip-address end-ip-address

undo { source-address | destination-address } ip-address

undo { source-address | destination-address } ip-address mask-lenth

undo { source-address | destination-address } ip-address mask mask

undo { source-address | destination-address } range start-ip-address end-ip-address

Parameters

Parameter	Description	Value
ip-address	Specifies an IP address or network segment for advanced search.	The value is in dotted decimal notation.
mask	Specifies a subnet mask of the IP address for advanced search.	-
mask-lenth	Specifies the mask length of the IP address for advanced search.	The value is an integer ranging from 1 to 32.
start-ip-address	Specifies the start IP address for advanced search.	The value is in dotted decimal notation.
end-ip-address	Specifies the end IP address for advanced search.	The value is in dotted decimal notation.

Views

User-defined report view

Default Level

2: Configuration level

Usage Guidelines

By default, no source or destination address is specified in the user-defined report view for advanced search.

Before running the source-address or destination-address command, ensure that the hard disk is in position and the report type command has been used to set a user-defined report type.

Only the USG6000E (not including USG6510E/6510E-POE/6530E) support this command.

Example

# Set the source address 10.10.10.1 in the user-defined report view for advanced search.

<sysname> system-view
[sysname]log user-defined-report policy name
[sysname-userde-defined-report-name]report type traffic
[sysname-userde-defined-report-name]source-address 10.10.10.1