status ( Address pool view )

Function

The status command configures the working status of the address pool.

The undo status command restores the default status of address pool.

status { maintenance | inactive }

undo status

Parameter	Description	Value
maintenance	Indicates the maintenance status. When new traffic is generated, the address pool cannot assign new IP addresses, and existing traffic ages based on the aging time.	-
inactive	Indicates the inactive status. When new traffic is generated, the address pool cannot assign new IP addresses, and existing traffic ages immediately.	-

Parameter

Description

Value

maintenance

Indicates the maintenance status.

When new traffic is generated, the address pool cannot assign new IP addresses, and existing traffic ages based on the aging time.

inactive

Indicates the inactive status.

When new traffic is generated, the address pool cannot assign new IP addresses, and existing traffic ages immediately.

Address pool view

2: Configuration level

By default, the working status of the address pool is active, it indicates that the address pool can be normally used and aged.

# Configure the working status of NAT address pool 1 to be maintenance.

<sysname> system-view
[sysname] nat address-group nataddr 1
[sysname-address-group-nataddr] status maintenance