lacp priority-command-mode

Function

The lacp priority-command-mode command sets a Link Aggregation Control Protocol (LACP) system priority configuration mode.

The undo lacp priority-command-mode command restores the default LACP system priority configuration mode.

By default, the LACP system priority configuration mode is default.

lacp priority-command-mode { default | system-priority }

undo lacp priority-command-mode

Parameter	Description	Value
default	Sets the LACP system priority configuration mode to default. In default mode, the LACP system priority is configured using the lacp priority command in the system view.	-
system-priority	Sets the LACP system priority configuration mode to system-priority. In system-priority mode, the LACP system priority is configured using the lacp system-priority command in the system view.	-

Parameter

Description

Value

default

Sets the LACP system priority configuration mode to default.

In default mode, the LACP system priority is configured using the lacp priority command in the system view.

system-priority

Sets the LACP system priority configuration mode to system-priority.

In system-priority mode, the LACP system priority is configured using the lacp system-priority command in the system view.

System view

2: Configuration level

Precautions

When running the lacp priority-command-mode command, note the following points:

If you specify default in the command, the LACP system priority and LACP interface priority configurations still use the same command (lacp priority priority).
If you specify system-priority in the command, run the lacp system-priority priority command to configure the LACP system priority and run the lacp priority priority command to configure the LACP interface priority.

# Set the LACP system priority configuration mode to system-priority.

<sysname> system-view

[sysname] lacp priority-command-mode system-priority