mpls (interface view)

Function

The mpls command enables MPLS on an interface.

The undo mpls command disables MPLS on an interface.

By default, no interface is enabled with MPLS.

Format

mpls

undo mpls

Parameters

None

Views

Ethernet interface view, Ethernet sub-interface view, Eth-Trunk interface view, Eth-Trunk sub-interface view, Tunnel interface view, Dialer interface view, VLANIF interface view, Virtual-Template interface view

Default Level

2: Configuration level

Usage Guidelines

Usage Scenario

On a network where MPLS services are deployed, after enabling MPLS on a node, enable MPLS on the interfaces of the node before performing other MPLS configurations.

Prerequisites

MPLS has been enabled globally using the mpls (system view) command.

Configuration Impact

After the mpls command is run, MPLS is enabled on the interface.

Precautions

Running the undo mpls command in the interface view deletes all MPLS configurations on the interface.

Example

# Enable MPLS on the interface.

<sysname> system-view

[sysname] interface GigabitEthernet 0/0/0
[sysname-GigabitEthernet0/0/0] mpls