ospf suppress-flapping peer disable

Function

The ospf suppress-flapping peer disable command disables OSPF neighbor relationship flapping suppression from an interface.

The undo ospf suppress-flapping peer disable command enables OSPF neighbor relationship flapping suppression on an interface.

By default, OSPF neighbor relationship flapping suppression is enabled on all interfaces.

Format

ospf suppress-flapping peer disable

undo ospf suppress-flapping peer disable

Parameters

None

Views

Ethernet interface view, Ethernet sub-interface view, Eth-Trunk interface view, Eth-Trunk sub-interface view, Tunnel interface view, Dialer interface view, VLANIF interface view, Virtual-Template interface view, BDIF interface view

Default Level

2: Configuration level

Usage Guidelines

Usage Scenario

By default, OSPF neighbor relationship flapping suppression is enabled on all interfaces in the same OSPF process. To disable the function from one of the interfaces, run the ospf suppress-flapping peer disable command.

When an interface enters the flapping suppression state, all neighbor relationships on the interface enter the state accordingly.

Prerequisites

OSPF neighbor relationship flapping suppression must have been enabled globally before you enable the function on an interface using the undo ospf suppress-flapping peer disable command. By default, the function is enabled globally. If it is disabled, run the undo suppress-flapping peer disable command to enable it first.

Example

# Disable OSPF neighbor relationship flapping suppression from GigabitEthernet 0/0/1.

<sysname> system-view

[sysname] interface GigabitEthernet 0/0/1

[sysname-GigabitEthernet0/0/1] ospf suppress-flapping peer disable