The ospfv3 area command enables the OSPFv3 process on an interface and specifies the area the process belongs to.
The undo ospfv3 area command disables the OSPFv3 process on the interface.
By default, the OSPFv3 protocol is not enabled on the interface.
ospfv3 process-id area area-id [ instance instance-id ]
undo ospfv3 process-id area area-id [ instance instance-id ]
| Parameter | Description | Value |
|---|---|---|
| process-id | Specifies the OSPFv3 process ID. | The value is an integer ranging from 1 to 65535. |
| area area-id | Specifies the OSPFv3 area ID. | The value of the area ID can be a decimal integer or in the IPv4 address format. The integer ranges from 0 to 4294967295. |
| instance instance-id | Specifies the instance ID of the interface. | The value is an integer ranging from 0 to 255. By default, it is 0. |
Ethernet interface view, Ethernet sub-interface view, Eth-Trunk interface view, Eth-Trunk sub-interface view, Tunnel interface view, Loopback interface view, Dialer interface view, VLANIF interface view, Virtual-Template interface view, BDIF interface view
Before configuring this command, run the ipv6 enable command to enable IPv6 in the interface view.