pim holdtime join-prune

Function

The pim holdtime join-prune command sets the holdtime in a Join/Prune message sent by the PIM interface.

The undo pim holdtime join-prune command restores the default value of the holdtime.

Format

pim holdtime join-prune interval

undo pim holdtime join-prune

Parameters

Parameter	Description	Value
interval	Specifies the value of holdtime in a Join/Prune message sent by the PIM interface.	The value is an integer that ranges from 1 to 65535, in seconds.

Views

Interface view

Default Level

2: Configuration level

Usage Guidelines

By default, the holdtime in a Join/Prune message sent by the PIM interface is 210 seconds.

FWs that receive Join/Prune messages set the time during which the downstream interface keeps the Join or Prune state according to holdtime in the Join/Prune messages.

This command functions in the interface view in the same way as the holdtime join-prune (IPv4) command in the PIM view, except for the view. By default, if the configuration on the interface is not done, the value configured in the PIM view is used; otherwise, the value configured in the interface view is used.

You must run the multicast routing-enable command to enable the multicast function before using the command.

Example

# Set the holdtime in a Join/Prune message sent by the PIM interface to 280 seconds.

<sysname> system-view
[sysname] multicast routing-enable
[sysname] interface GigabitEthernet 0/0/0
[sysname-GigabitEthernet0/0/0] pim holdtime join-prune 280