Configuring the Ingress for a Static LSP
This section describes how to configure a static LSP on the ingress. Before you set up a static LSP, configure the ingress manually.
Procedure
- Access the system view.
system-view
- Configure the LSR as the ingress on the specified LSP.
static-lsp ingress lsp-name destination ip-address { mask-length | mask } { nexthop next-hop-address | outgoing-interface interface-type interface-number } * out-label out-label
To modify the destination destination-address, nexthop next-hop-address, outgoing-interface interface-type interface-number, or out-label out-label, run the static-lsp ingress command to set a new value. There is no need to run the undo static-lsp ingress command before changing a configured value.
It is recommended that you set up a static LSP by specifying a next hop. Ensure that the local routing table contains the route entries, including the destination IP address and the next hop IP addresses of the LSP to be established.