Configuring the Transit Node for a Static LSP

Procedure

1. Access the system view.

   system-view

2. Configure the LSR as the transit node on the specified LSP.

   static-lsp transit lsp-name [ incoming-interface interface-type interface-number ] in-label in-label { nexthop next-hop-address | outgoing-interface interface-type interface-number } * out-label out-label

   To modify the incoming-interface interface-type interface-number, in-label in-label, nexthop next-hop-address, outgoing-interface interface-type interface-number, or out-label out-label, run the static-lsp transit command to set a new value. There is no need to run the undo static-lsp transit command before changing a configured value.

   

   It is recommended that you set up a static LSP by specifying a next hop address. In addition, ensure that the local routing table contains the route entries, including the destination IP address and the next hop IP address of the LSP to be established.