Configuring the Egress for a Static LSP

This section describes how to configure a static LSP on the egress. Before you set up a static LSP, configure the egress manually.

Perform the following steps on the LSR to be configured as the egress:

Access the system view.
```
system-view
```
Configure the LSR as the egress on the specified LSP.
```
static-lsp egress lsp-name [ incoming-interface interface-type interface-number ] in-label in-label
```
To modify the incoming-interface interface-type interface-number or in-label in-label, run the static-lsp egress command to set a new value. There is no need to undo static-lsp egress command before changing a configured value.