Configuring Ping Proxy Using the Web UI

Procedure

1. Choose Policy > Security Protection > Ping Proxy.
2. On the Ping Proxy Management page, select Enable for Ping Proxy.
3. Click Apply.
4. On the Ping Proxy List page, click Add.
5. Configure a ping proxy policy. For parameter description, see Table 1.

   Table 1 Parameters for configuring ping proxy

   Parameter	Description
   Name	Enter a name for the ping proxy policy. The value can be a string of a maximum of 32 characters without any question mark (?), comma (,), quotation mark ("), or hyphen (-) and must not be all or any.
   Server IP Address	Set the IP address of the server that requires ping proxy. The parameter can be configured as a single IPv4 address.
   Detection Interval	Set the interval for sending probe packets. After you select Enable for ping proxy, the FW sends probe packets in the specified interval to detect the server status. If the FW receives a response packet from the server, the server status is Up. If the FW does not receive any response packet from the server and the number of probes reaches Maximum tries, the server status is Down.
   Maximum Tries	Set the number of retransmission times. If the FW does not receive any reply packets from the server and the number of probes reaches Maximum tries, the server status is Down.
   Client Address	Set the client address range to be proxied. The value can be IPv4 addresses or address groups. You can also set it to any which represents any address or address group. A maximum of three client addresses or address groups are allowed.

6. Click OK.