firewall dynamic-resource used-up alarm sslvpn-ip-address threshold

Function

The firewall dynamic-resource used-up alarm sslvpn-ip-address threshold command sets an alarm threshold for the IP address usage of a virtual gateway address pool.

The undo firewall dynamic-resource used-up alarm sslvpn-ip-address threshold command restores the default alarm threshold for the IP address usage of a virtual gateway address pool.

Format

firewall dynamic-resource used-up alarm sslvpn-ip-address threshold threshold

undo firewall dynamic-resource used-up alarm sslvpn-ip-address threshold

Parameters

Parameter	Description	Value
threshold	Specifies an alarm threshold for the IP address usage of a virtual gateway address pool.	The value is an integer ranging from 1 to 100, in percentage. The default value is 80.

Views

System view

Default Level

3: Management level

Usage Guidelines

The alarm threshold applies to every virtual gateway address pool.

Before setting an alarm threshold, run the firewall dynamic-resource used-up alarm sslvpn-ip-address enable or firewall dynamic-resource used-up alarm all enable command to enable the function of sending an alarm after the IP address usage of a virtual gateway address pool reaches the threshold. If the alarm function is disabled, the device will not send alarms even if an alarm threshold is set.

After the IP address usage of a virtual gateway address pool reaches the alarm threshold, the device sends the alarm NEM_1.3.6.1.4.1.2011.6.122.44.1.3.1 hwSecSslvpnNetPoolOverThreshold. After the IP address usage falls below 95% of the alarm threshold, the device sends the alarm NEM_1.3.6.1.4.1.2011.6.122.44.1.3.2 hwSecSslvpnNetPoolBelowThreshold.

Example

# Set the alarm threshold to 85% for the IP address usage of a virtual gateway address pool.

<sysname> system-view
[sysname] firewall dynamic-resource used-up alarm sslvpn-ip-address enable
[sysname] firewall dynamic-resource used-up alarm sslvpn-ip-address threshold 85