The hrp standby config enable command in the active device enables certain function in standby device.
The undo hrp standby config enable command in the active device disables certain function in standby device.
This function is disabled by default. All information to be backed up must be configured on the active FW and then backed up to the standby FW.
After enabling this function, you can configure all information that can be backed up on the standby FW, and the configurations can be synchronized to the active FW. If conflicting settings are configured on the active and standby FWs, the settings configured later overrides previously configured settings.
This hrp standby config enable command can be configured on the two FWs in hot standby deployment and can be mutually backed up. If this command is configured on the active and standby devices, the configuration performed later overrides the configuration performed previously.