Installing a 600 mm Deep Device

Mounting a Device in a Cabinet

Install the USG6680E, USG6712E, USG6716E to the 19-inch standard cabinet through the expandable rear mounting ears.

Connecting a PGND Cable

Connecting the PGND cable of a USG6680E, USG6712E, USG6716E correctly is a key measure of surge protection and resistance to interference. Before using the USG6680E, USG6712E, USG6716E, correctly connect the PGND cable. Otherwise, the USG may be damaged.

Installing a Hard Disk

This section describes how to install a hard disk units for the first time to avoid hard disk damage.

Connecting a Console Cable

After connecting a PC to the console port of a USG6680E, USG6712E, USG6716E with a console cable, you can use the terminal emulation program on the PC to access the command configuration interface of the USG6680E, USG6712E, USG6716E.

Installing Optical Transceivers and Connecting Optical Fibers

This section describes how to install optical transceivers on the 10GE, 40GE, 100GE optical ports of the USG and connect them to the ports of the peer device using optical fibers according to the network plan.

Connecting AC Power Cables

The USG6680E, USG6712E, USG6716E comes with two AC power module. Each AC power module requires an AC power cable. When two AC power modules are used, connect power cables to both AC power modules.

Powering On or Off the USG6680E, USG6712E, USG6716E

This section describes how to power on or off the USG6680E, USG6712E, USG6716E. To ensure the normal start and security of the USG6680E, USG6712E, USG6716E, strictly follow the operation guide to power on or off the USG6680E, USG6712E, USG6716E.