Interface Configuration Using the CLI

Configuring a Management Interface

This section describes how to configure a Management Interface for you to manage the FW.

Configuring a Layer-3 Ethernet Interface

This section describes how to configure a Layer-3 Ethernet interface that supports the routing and forwarding functions.

Configuring a Layer-2 Ethernet Interface

This section describes how to configure a Layer-2 Ethernet interface that forwards Layer-2 frames.

Configuring a Layer-3 Ethernet Subinterface

This section describes how to configure a Layer-3 Ethernet subinterface.

Configuring a Layer-2 Ethernet Subinterface

This section describes how to configure a Layer-2 Ethernet subinterface.

Configuring a VLAN Interface

This section describes how to configure a VLAN interface for inter-VLAN communication.

Configuring BDIF Interfaces (VXLAN Interfaces)

You can configure Virtual eXtensible Local Area Network (VXLAN) interfaces for communication between VXLANs and between a VXLAN and a non-VXLAN.

Configuring an Eth-Trunk Interface

This section describes how to configure an Eth-Trunk interface, which can load-balance traffic between devices, increase bandwidth, and improve link reliability.

Configuring a Loopback Interface

Configuring a Null Interface

Configuring a Tunnel Interface

Tunnel interfaces are logical interfaces that have Layer-3 features. Devices on the two ends of a tunnel send, receive, identify, and process tunnel packets.

Configuring a Virtual Template Interface

Configuring Interface Access Management

Maintaining Interfaces

This section describes how to display the configuration and status of a specific interface.