Interface Configuration Using the Web UI

Configuring a Management Interface

This section describes how to configure a Management Interface for you to manage the FW.

Configuring a Layer-3 Ethernet Interface

This section describes how to configure a Layer-3 Ethernet interface. A Layer-3 Ethernet interface supports the routing functions and uses routes to forward packets.

Configuring a Layer-2 Ethernet Interface

This section describes how to configure a Layer-2 Ethernet interface that forwards Layer-2 frames.

Configuring a Layer-3 Ethernet Subinterface

This section describes how to configure a Layer-3 Ethernet subinterface.

Configuring a Layer-2 Ethernet Subinterface

This section describes how to configure a Layer-2 Ethernet subinterface.

Configuring a VLAN Interface

This section describes how to configure a virtual local area network (VLAN) interface. VLAN interfaces transmit packets between VLANs.

Configuring a VXLAN Interface

You can configure Virtual eXtensible Local Area Network (VXLAN) interfaces for communication between VXLANs and between a VXLAN and a non-VXLAN.

Configuring an Eth-Trunk Interface

This section describes how to configure an Eth-Trunk interface. An Eth-Trunk interface balances traffic loads across devices, increases bandwidth, and improves traffic reliability.

Configuring a Loopback Interface

This section describes how to configure a loopback interface. Once created, a loopback interface remains in the Up state. Loopback interface characteristics are used to improve reliability.

Configuring the Tunnel Interface

Tunnel interfaces enable packet encapsulation and forwarding through tunnels.